控制按钮开关是操作人员和控制装置之间的中间环节,可见正确的安装控制按钮开关是非常重要的,红宝电气小编给大家详细介绍下控制按钮开关的安装位置及接线过程。
The control button switch is the intermediate link between the operator and the control device. It can be seen that the correct installation of the control button switch is very important. Hongbao Electric has compiled a small section to introduce in detail the installation position and wiring process of the control button switch.
1、安装位置
Installation position
在安装控制按钮时,先测量出按钮螺纹的直径,在控制面板上钻出安装孔,退出按钮螺帽,将按钮螺纹柱由控制面板的背面穿出,调整螺纹柱上的挡块至适当位置,再从控制面板正面将钮相旋上螺纹柱并紧固。
When installing the control button, first measure the diameter of the button thread, drill the installation hole on the control panel, exit the button nut, thread the button threaded column through the back of the control panel, adjust the stop on the threaded column to the appropriate position, and then screw the button on the threaded column from the front of the control panel and tighten it.
将按钮安装在面板上时,应布置整齐,排列合理。可根据电动机启动的先后次序.从上到下或从左到右排列。
When the buttons are installed on the panel, they should be arranged orderly and arranged reasonably. It can be arranged from top to bottom or from left to right according to the order of motor starting.
同一个设备运动部件的几种不同的工作状态,包括上下、前后、左右、松紧等,需要将每一对相反状态的按钮安装在一起。
Several different working states of moving parts of the same equipment, including up and down, front and back, left and right, tightness, etc., need to install each pair of buttons in the opposite state together.
为应付紧急情况,当按钮板上安装的按钮较多时,用红色蘑菇头按钮作总停按钮,并安装在显眼且易操作的地方。
In order to deal with emergencies, when there are more buttons installed on the button board, the red mushroom head button is used as the main stop button, and it is installed in a conspicuous and easy to operate place.
2、安装接线
Installation wiring
一般情况下,一只按钮总有一副动合触头及一副动断触头,连线之前用万用表电阻挡分清相对应的触头。
In general, a button always has a pair of moving contact and a pair of moving and breaking contacts. Before connecting, use the multimeter resistance to distinguish the corresponding contact.
例外的情况是,有的各有两副触头并带有指示灯,在接线时需要多注意一下。
The exception is that some of them have two pairs of contacts with indicator light, which should be paid more attention to when wiring.
安装按钮的按钮板和按钮盒必须是金属的,并设法使它们与设备总接地母线相连接,对于悬挂式按钮必须设有专用接地线,不得借用金属管作为地线。
The button board and box for installing buttons must be metal, and try to connect them with the general grounding bus of the equipment. For hanging buttons, special grounding wire must be set, and metal tube is not allowed to be used as ground wire.